The CRC Wild Goose Chase: PPP Does What?!?!?!

Jason Sachs October 23, 20142 comments

I got a bad feeling yesterday when I had to include reference information about a 16-bit CRC in a serial protocol document I was writing. And I knew it wasn’t going to end well.

The last time I looked into CRC algorithms was about five years ago. And the time before that… sometime back in 2004 or 2005? It seems like it comes up periodically, like the seventeen-year locust or sunspots or El...


Reverse engineering wireless wall outlets

Fabien Le Mentec July 19, 2014
Introduction

I am improving the domotics framework that I described in a previous article:http://www.embeddedrelated.com/showarticle/605.php

I want to support wireless wall outlets, allowing me to switch devices power from a remote location over HTTP.

To do so, I could design my own wireless wall outlets and use a hardware similar to the previous one, based on the NRF905 chipset. The problem is that such a product would not be certified, and that would be an issue regarding the home insurance, in case of...


Using a RTLSDR dongle to validate NRF905 configuration

Fabien Le Mentec January 27, 20146 comments
I am currently working on a system to monitor the garage door status from my flat. Both places are 7 floors apart, and I need to send the data wirelessly. I chose to operate on the 433MHz carrier, and I ordered 2 PTR8000 modules: http://www.electrodragon.com/w/NRF905_Transceiver_433MHz-Wireless_ModuleThe PTR8000 is based on the dual band sub 1GHz NRF905 chipset from NORDICSEMI:

MSP430 LaunchPad Tutorial - Part 4 - UART Transmission

Enrico Garante July 3, 201316 comments

Today we are going to learn how to communicate using UART with the Launchpad. For this purpose I will replace the default microcontroller that comes with the board with the MSP430G2553. It is the most powerful device in the MSP430 Value Line and it comes with an integrated hardware UART module, along with 16 Kb of Flash memory, 512 bytes of SRAM and an 8-channel, 10 bit ADC.

UART communication can be useful when dealing with sensors: as a basic...


Endianness and Serial Communication

Stephen Friederichs May 20, 2013

Endianness is a consideration that is easily overlooked in the design of embedded systems. I myself am amply guilty of this oversight. It’s something you don’t ever have to worry about if you’re only working with a single processor or two processors that have the same endianness.  You can even avoid it if you have two processors that have different endianness but never transmit data between themselves that consists of more than one byte.  It’s easy to lull yourself into a false sense of security that you’ll never have to worry about endianness -...


Help, My Serial Data Has Been Framed: How To Handle Packets When All You Have Are Streams

Jason Sachs December 11, 20118 comments

Today we're going to talk about data framing and something called COBS, which will make your life easier the next time you use serial communications on an embedded system -- but first, here's a quiz:

Quick Diversion, Part I: Which of the following is the toughest area of electrical engineering? analog circuit design digital circuit design power electronics communications radiofrequency (RF) circuit design electromagnetic compatibility...