68HC1 | 812A4 | 9S12DP256 | Bootloader | CodeWarrior | D60A | Debugger | DP256 | ECT | EEPROM | EVB | Flash | HC1 | HCS12 | I2C | IAR | ICC1 | Interrupts | LCD | M68KIT912DP256 | MC9S12DP256 | MC9S12DP256B | Metrowerks | Motor | MSCAN | Multilink | PLL | Quadrature | SDI | SPI | Transceiver | XFC

i want to know the initialisation steps of mc9s12dj256b when use it for eeprom writing
i am using the following code,

// Mode Selected is Normal Expanded Wide Mode
MODE = 0xE0;

// set the PEAR for overlaying EEPROM as RAM
PEAR = 0x8C;

//enable the Flash EEPROM or ROM memory in the memory map.
MISC = 0x03;//$$03 to 01 for EEProm testing

and eeprom registers initialisation.

is it enough for my eeprom writing.if anyone have the details
please share with me

thanks
simi

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

Scanning of this message and addition of this footer is performed
by E-mail Content Filter Software at ADA in conjunction with McAfee
Virus detection software
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
[Non-text portions of this message have been removed]
------------------------------------



(You need to be a member of 68hc12 -- send a blank email to 68hc12-subscribe@yahoogroups.com )