68HC1 | 812A4 | 9S12DP256 | Bootloader | CodeWarrior | D60A | Debugger | DP256 | ECT | EEPROM | EVB | Flash | HC1 | HCS12 | I2C | IAR | ICC1 | Interrupts | LCD | M68KIT912DP256 | MC9S12DP256 | MC9S12DP256B | Metrowerks | Motor | MSCAN | Multilink | PLL | Quadrature | SDI | SPI | Transceiver | XFC

I am very new to programming/HC12 so please bare with me. The code i
>am currently dealing with is something my professor made available so
>that i can modify it. I am trying to run a heater using the Dragon 12
>with a relay hooked up between the two. I already have a thermistor
>set up on the board with temperature being displayed to the LCD. I am
>wanting the heater to turn on when the temp is below 270 and turn off
>when the temp is above 280. I currently have the relay hooked up to
>PB2 and ground. This is where my programming knowledge ends. I am
>assuming it is just a matter of turning the relay either high or low
>according to my previously mentioned criteria. What i am wanting to
>know is what i need to add to my Freescale CodeWarrior C code to cause
>these things to happen. If there is any other information you need,
>let me know. Thanks for your help.
>
>-Bryan
>
------------------------------------

______________________________
Stellaris® MCU Family: New Parts, New Package, New Price.


(You need to be a member of 68hc12 -- send a blank email to 68hc12-subscribe@yahoogroups.com )