I have connected on "Timer/Counter Channel 0" port A a rpm sensor (square signal every spark) and a speed sensor (square signal every axle rotation). Now my question is: is possible to make measurements independently on A and B channel or not? Or I have to change my hardware layout? If I have understand well I can make diffrent measurements, and Register A is loaded with "TC Counter Value register(TC_CV)" as is Register B, but if I want a new count i have to reset TC_CV and this affect Register A and B at the same time.
So if I reset TC_CV for Register A my register B value will be wrong and vice versa for Register A if i reset TC_CV for register B.

Is it right?

Best regards

------------------------------------



(You need to be a member of AT91SAM -- send a blank email to AT91SAM-subscribe@yahoogroups.com )