AT90S2313 | AT90S8515 | ATMega | ATmega128 | ECL | FETS | IAR | Keyboard | LCD | STK50 | TMOS | UART

Hi,

Does any one know where to get a bootloader for ATmega8535. I don't
have any compiler available and just need .hex to test some application.

Thanks for any info

Mike



(You need to be a member of avrclub -- send a blank email to avrclub-subscribe@yahoogroups.com )

On AVRfreaks.net, the BLIPS donated project should work for the mega8535
without more that 5 minutes'

Change. It's written in ASM, not C, in order to fit in 512B of flash, even
with fast block mode transfers. There's also a GUI based PC side program for
it.

_____

From: a...@yahoogroups.com [mailto:a...@yahoogroups.com] On Behalf Of
mirekwind
Sent: Saturday, October 28, 2006 2:18 PM
To: a...@yahoogroups.com
Subject: [AVR club] bootloader for mega8535

Hi,

Does any one know where to get a bootloader for ATmega8535. I don't
have any compiler available and just need .hex to test some application.

Thanks for any info

Mike

[Non-text portions of this message have been removed]



(You need to be a member of avrclub -- send a blank email to avrclub-subscribe@yahoogroups.com )

Steve,

Thanks so much. This is an excellent program!
Like you said, it took me about 5 minuts to get it done. I made only
small changes to clock and baud rates. First run of BLIPS generated
an error .xml file not found.
I run BLIPS from E: drive and path to .xml points correctly to C:
drive, where AVRStudio4 is installed. So, I copied .xml to a new
folder on E: drive and it works fine.

Thanks again,

Mike
--- In a...@yahoogroups.com, "stevech" wrote:
>
> On AVRfreaks.net, the BLIPS donated project should work for the
mega8535
> without more that 5 minutes'
>
> Change. It's written in ASM, not C, in order to fit in 512B of
flash, even
> with fast block mode transfers. There's also a GUI based PC side
program for
> it.
>
>
>
> _____
>
> From: a...@yahoogroups.com [mailto:a...@yahoogroups.com] On
Behalf Of
> mirekwind
> Sent: Saturday, October 28, 2006 2:18 PM
> To: a...@yahoogroups.com
> Subject: [AVR club] bootloader for mega8535
>
>
>
> Hi,
>
> Does any one know where to get a bootloader for ATmega8535. I don't
> have any compiler available and just need .hex to test some
application.
>
> Thanks for any info
>
> Mike
>
>
>
> [Non-text portions of this message have been removed]
>



(You need to be a member of avrclub -- send a blank email to avrclub-subscribe@yahoogroups.com )