AT90S2313 | AT90S8515 | ATMega | ATmega128 | ECL | FETS | IAR | Keyboard | LCD | STK50 | TMOS | UART

Hello,
>> Cannot program the ATmega128 using SPI
Maybe you re making a mistake in programming fuse bit.

3 years ago, i have making the same and i restored 4 µc
with this:
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
Special "Rescue"-Mode: When the Bootloader-Enable jumper is set during
power-up a clock-signal (0,73MHz) is available at the "Rescue-Clock"
pin-header.
With this clock-signal connected to the XTAL1-pin of an AVR a
misconfigured
controller can be accessed and reprogrammed.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
Good luck

Cordialement
François Rigaud
---------------------------------
François Rigaud
Observatoire de Paris-Meudon
GEPI
5 pl J. Janssen 92195 Meudon



(You need to be a member of avrclub -- send a blank email to avrclub-subscribe@yahoogroups.com )