AT90S2313 | AT90S8515 | ATMega | ATmega128 | ECL | FETS | IAR | Keyboard | LCD | STK50 | TMOS | UART

hi everybody
I have two problem that I think you can help me.both are about script
file in pony prog .
in script file using in pony prog there is a section about
read_calibration . I am wondering that I just use this in the term
that I use internal oscilator or not ? what happen if I use this in
the term that I use external oscilator ?
and the second problem is that how I can find the adress of
calibration byte , in the example it is shown that it is 3ff for
attiny 12 and 100 for atmega 128 but what is it for atmega8?
thanks in advance
parlar

------------------------------------



(You need to be a member of avrclub -- send a blank email to avrclub-subscribe@yahoogroups.com )

I don't use Ponyprog so I can't answer that question. But there is no
calibration byte in the ATMega8,

Zack

On Sat, 23 Aug 2008, Ayla wrote:

> hi everybody
> I have two problem that I think you can help me.both are about script
> file in pony prog .
> in script file using in pony prog there is a section about
> read_calibration . I am wondering that I just use this in the term
> that I use internal oscilator or not ? what happen if I use this in
> the term that I use external oscilator ?
> and the second problem is that how I can find the adress of
> calibration byte , in the example it is shown that it is 3ff for
> attiny 12 and 100 for atmega 128 but what is it for atmega8?
> thanks in advance
> parlar
>

------------------------------------



(You need to be a member of avrclub -- send a blank email to avrclub-subscribe@yahoogroups.com )