Accelerometer | ADC | ADXL | Adxl20 | AVR | BasicStamp | BX-35 | BX28 | BX35 | COM3 | Compiler | Downloader | EEPROM | Electromagnet | GetADC | GP2D1 | GPS | I2C | IDE | Keypad | LCD | LCD+ | MIDI | Motors | Multitasking | Netmedia | Networking | PCB | PID | PlaySound | PWM | Relays | RTC | Servo | ShiftOut | SitePlayer | SPI | Stack | Timer | USB

COM3 Voltage 5V to 3V   [2 Articles]

I have configured 2 pins for com3 to communicate with a Siemens C35 using its RX,TX pins so far so good i can communicate with the cellphone, but in order to the cellphone don't lo...

Parallax to BX-24   [2 Articles]

Is there an easy way to convert a program written for the Javelin Stamp from Parallax to the BX-24? Danny Groff CDex Inc. [Non-text portions of this message have been remov...

Posters: Forum messages scanned for spam

Folks: - Yahoo is now scanning your forum posts, deciding what looks like spam. Forum spam is delivered to the moderator who decides what to do with it. Delays or unposted...

RE: Digest Number 2752

Ian, The quick answer is, yes, the BUZ71A power MOSFET is more than adequate for the purpose at 12A, 50V, Vgs of 4V max and RDSon of 0.12 Ohm. Connect the Gate to the appropri...

BXDS w/BX-01 RAM sandwich and LCD

I have been using the BXDS w/BX-01 alone, but I have the RAM sandwich and LCD. I haven't used them yet, because it seems like I will lose the use of many of the pins of the BX-...

Sony PS Controller and BX-01: ShiftIn ShiftOut replacement

I am trying to see if I can read the Sony PS2 Controller with the BX- 01, but need to figure out the right way to replace shiftIn and shiftOut. I am working off the code for the...

RF Link Issues   [9 Articles]

Hello I am using a RF Transmitter/Receiver pair from here: http://www.sparkfun.com/commerce/product_info.php?products_id=7813 I wrote this code in the BX24 to test the RF Lin...

Re: Digest Number 2752   [2 Articles]

www.bgmicro.com is only about $6 shipping. Also check All Electronics and Alltronics. National may have do samples. ----- Original Message ----- > That would be good, but do ...

did i fry my BX24?

I was trying to program it, and the dev. kit was powered by 12 volts. The BX24 got hot, I let it cool for 6 hours (it cooled in like 5 minutes, tho) and now it won't program. T...

Button code not working   [21 Articles]

Hi, I'm trying to use a button, and I am completely confused. When the button is pressed (closed), I want pin 11 to go HIGH. Here is my current code: Option Explicit Dim s...