Accelerometer | ADC | ADXL | Adxl20 | AVR | BasicStamp | BX-35 | BX28 | BX35 | COM3 | Compiler | Downloader | EEPROM | Electromagnet | GetADC | GP2D1 | GPS | I2C | IDE | Keypad | LCD | LCD+ | MIDI | Motors | Multitasking | Netmedia | Networking | PCB | PID | PlaySound | PWM | Relays | RTC | Servo | ShiftOut | SitePlayer | SPI | Stack | Timer | USB

hi,
i'm getting the error "unable to halt the basic x" because i'm not
using a develpmental board...don't have a reset button...i was
wondering how to use the reset pin 22 on the basic x? or what's the
next best thing to do?

CHeers,

Vergel



(You need to be a member of basicx -- send a blank email to basicx-subscribe@yahoogroups.com )

At 11:22 AM 10/10/2007, you wrote:
>Put a switch - just a momentary switch, or a removable jumper -
>between pin22 and ground (pin23 or pin4). Ground pin22, then remove
>the ground to restart the processor.

<---Or just cycle power...

Ken
(and I think you're right - why read the documentation when you just
post to a list?)



(You need to be a member of basicx -- send a blank email to basicx-subscribe@yahoogroups.com )

> ... how to use the reset pin 22...

I suspect you haven't received an answer to this because the question
suggests that you haven't read the documentation, or looked at a
processor or board schematic, or searched the messages in the archive
here - any of which will provide an answer that you might find helpful.

Put a switch - just a momentary switch, or a removable jumper -
between pin22 and ground (pin23 or pin4). Ground pin22, then remove
the ground to restart the processor.
Tom



(You need to be a member of basicx -- send a blank email to basicx-subscribe@yahoogroups.com )