Sign in
Search basicx
Subscribe to basicx
basicx by Keywords
Accelerometer | ADC | ADXL | Adxl20 | AVR | BasicStamp | BX-35 | BX28 | BX35 | COM3 | Compiler | Downloader | EEPROM | Electromagnet | GetADC | GP2D1 | GPS | I2C | IDE | Keypad | LCD | LCD+ | MIDI | Motors | Multitasking | Netmedia | Networking | PCB | PID | PlaySound | PWM | Relays | RTC | Servo | ShiftOut | SitePlayer | SPI | Stack | Timer | USB
Ads
Discussion Groups
See Also
Discussion Groups | BasicX | HELP!! Problems with Servo 8T and its software ServoGUI
Discussion forum for the BasicX family of microcontroller chips.
HELP!! Problems with Servo 8T and its software ServoGUI - Author Unknown - Nov 8 3:56:00 2001
|
Hi, I am currently using the Servo 8T to control the Hitec 50 servo. However, the servo does not move to the central position and the LED does not light up when the power is connected. A check on the pins S1,..,8 shows that there is a 6v power but no signal. Moreover, which software should I use for the controller? Is it the hyperterminal? I tried that without sucess. For the software provided, servoGui, did anyone know how to use it? I cannot find the manual for it either on internet or CD provided. 1) What is module stated in servo setup referring to? Is module 1 equalvalent to S1 output? 2) What is sevo select in this case? 3) How do I control the position of the servo? Thank you for looking through my queries and Hope to hear from you all asap. Once again thank you. |
|
|
Stellaris® MCU Family: New Parts, New Package, New Price.
(You need to be a member of basicx -- send a blank email to basicx-subscribe@yahoogroups.com )
Re: HELP!! Problems with Servo 8T and its software ServoGUI - Tony Brenke - Nov 8 11:11:00 2001
|
http://www.web-hobbies.com/servo8t.html --- wrote: > Hi, > > I am currently using the Servo 8T to control the Hitec 50 servo. > However, the servo does not move to the central position and the LED > does not light up when the power is connected. A check on the pins > S1,..,8 shows that there is a 6v power but no signal. > > Moreover, which software should I use for the controller? Is it the > hyperterminal? I tried that without sucess. > > For the software provided, servoGui, did anyone know how to use it? I > cannot find the manual for it either on internet or CD provided. > > 1) What is module stated in servo setup referring to? Is module 1 > equalvalent to S1 output? > > 2) What is sevo select in this case? > > 3) How do I control the position of the servo? > Thank you for looking through my queries and Hope to hear from you > all asap. Once again thank you. > > > ===== Tony Brenke North Tacoma, WA __________________________________________________ |
(You need to be a member of basicx -- send a blank email to basicx-subscribe@yahoogroups.com )