2106 | ADC | ARM7 | Atmel | Bootloader | CAN | CrossStudio | CrossWorks | DDS | ECos | Ethernet | ETM | FIFO | FLASH | FPGA | GCC | GDB | GNU | GNUARM | GPIO | I2C | IAP | IAR | JTAG | Kickstart | LCD | Linux | LPC | LPC-E2294 | LPC2000 | LPC2100 | LPC2104 | Lpc2106 | Lpc210x | LPC2114 | LPC2119 | LPC2124 | LPC2129 | Lpc2138 | LPC213x | LPC21xx | LPC2210 | LPC2212 | LPC2214 | LPC2292 | LPC2294 | LPC2xxx | LPC3128 | MCB2100 | Olimex | Philips | PWM | Rowley | RTC | RTOS | SPI | SSP | UART | UART0 | UART1 | ULINK | USB | Watchdog | Wiggler

Hallo Im searching for any tutorials or help for JTAG debugging of the lpc2106. I heard that there are some problems with JTAG flash-programming!? Is it possible to program the flash or the ram with the JTAG-Adpater? I got the Olimex LPC-P1 Board and the ARM-JTAG for Parallel-Port also from Olimex. Thanks for any help...

(You need to be a member of lpc2000 -- send a blank email to lpc2000-subscribe@yahoogroups.com )

----- Original Message ----- From: "bwende1" <> To: <> Sent: Sunday, June 20, 2004 6:21 PM Subject: [lpc2000] JTAG Debugging of lpc2106 > Hallo > > Im searching for any tutorials or help for JTAG debugging of the > lpc2106. > > I heard that there are some problems with JTAG flash-programming!? > Is it possible to program the flash or the ram with the JTAG-Adpater? > > I got the Olimex LPC-P1 Board and the ARM-JTAG for Parallel-Port also > from Olimex. It depends on the tools you are using. Both RAM and Flash debugging are available with the CrossWorks tools, at any rate, and both may be programmed, of course. Leon Leon

(You need to be a member of lpc2000 -- send a blank email to lpc2000-subscribe@yahoogroups.com )

> It depends on the tools you are using. I use the Gnuarm toolchain. I would prefer free tools for debugging/programming. Benjamin

(You need to be a member of lpc2000 -- send a blank email to lpc2000-subscribe@yahoogroups.com )