2106 | ADC | ARM7 | Atmel | Bootloader | CAN | CrossStudio | CrossWorks | DDS | ECos | Ethernet | ETM | FIFO | FLASH | FPGA | GCC | GDB | GNU | GNUARM | GPIO | I2C | IAP | IAR | JTAG | Kickstart | LCD | Linux | LPC | LPC-E2294 | LPC2000 | LPC2100 | LPC2104 | Lpc2106 | Lpc210x | LPC2114 | LPC2119 | LPC2124 | LPC2129 | Lpc2138 | LPC213x | LPC21xx | LPC2210 | LPC2212 | LPC2214 | LPC2292 | LPC2294 | LPC2xxx | LPC3128 | MCB2100 | Olimex | Philips | PWM | Rowley | RTC | RTOS | SPI | SSP | UART | UART0 | UART1 | ULINK | USB | Watchdog | Wiggler

Hi, I'm using IAR workbench with an olimex lpc2468 board, I was trying to write the .hex file using the flashMagic, I was able to download it before without problem, but now when I try to use the flashmagic tool. i get the message failed to autobaud ! when I try to download the program with JTAG, usin IAR I can download it with success but, I run steps in debugging mode but it seems that code is not executed (my LCD p.e doesnt Init !!)
Can you help please ?
is it possible to overwirte the ISP code ??

Best Regards
Zakaria Nakrachi

------------------------------------



(You need to be a member of lpc2000 -- send a blank email to lpc2000-subscribe@yahoogroups.com )

--- In l...@yahoogroups.com, "zanakca" wrote:
>
> Hi, I'm using IAR workbench with an olimex lpc2468 board, I was
> trying to write the .hex file using the flashMagic, I was able to
> download it before without problem, but now when I try to use the
> flashmagic tool. i get the message failed to autobaud !

1. Go to:

http://www.flashmagictool.com/resources.html

2. Download the document:

"App Note 4 What to do if ISP does not work"

--
Chris Burrows
CFB Software
Armaide: LPC2xxx Development System
http://www.armaide.com

------------------------------------



(You need to be a member of lpc2000 -- send a blank email to lpc2000-subscribe@yahoogroups.com )