2106 | ADC | ARM7 | Atmel | Bootloader | CAN | CrossStudio | CrossWorks | DDS | ECos | Ethernet | ETM | FIFO | FLASH | FPGA | GCC | GDB | GNU | GNUARM | GPIO | I2C | IAP | IAR | JTAG | Kickstart | LCD | Linux | LPC | LPC-E2294 | LPC2000 | LPC2100 | LPC2104 | Lpc2106 | Lpc210x | LPC2114 | LPC2119 | LPC2124 | LPC2129 | Lpc2138 | LPC213x | LPC21xx | LPC2210 | LPC2212 | LPC2214 | LPC2292 | LPC2294 | LPC2xxx | LPC3128 | MCB2100 | Olimex | Philips | PWM | Rowley | RTC | RTOS | SPI | SSP | UART | UART0 | UART1 | ULINK | USB | Watchdog | Wiggler

Hi ! I am new in this group. I am working on a development board with a LPC2214 and CS8900A Ethernet-Chip. So my problem is the debugging: Is the Wiggler-Clone Schematic working with the actual OCRRemote ? Thanks for help !! Regards, Timo

(You need to be a member of lpc2000 -- send a blank email to lpc2000-subscribe@yahoogroups.com )

If it's any help, the Olimex "ARM-Jtag" Wiggler-clone adapter works correctly with the Olimex LPC-E2214 and LPC-E2294 boards, one of which I assume you are using. I'm using CrossStudio for development, it's so sweet! Bill T. http://www.kupercontrols.com --- In , "linuxianer99" <linuxianer99@y...> wrote: > > Hi ! > > I am new in this group. > I am working on a development board with a LPC2214 and CS8900A > Ethernet-Chip. > > So my problem is the debugging: > > Is the Wiggler-Clone Schematic working with the actual OCRRemote ? > > Thanks for help !! > > Regards, > Timo

(You need to be a member of lpc2000 -- send a blank email to lpc2000-subscribe@yahoogroups.com )