27c256 | 4K81H | 68HC11A1 | 68HC11P1 | 68hc24 | 68HC711E9 | 68HC811 | 8255 | A2D | ADC | ADC12138 | Am85C30 | BRCLR | Buffalo | CMOS | EEPROM | EPROM | Ethernet | EVB | EVBU | HC11E1 | HC11E9 | HC711E9 | Horray | ImageCraft | IRQ | Keypad | LCD | MC68HC11D0FN | MC68HC11E1CFU3 | MC68HC11F1 | MC68HC711E9 | MC68HC711E9CFN2 | Microcore11 | Microstamp11 | Minikit | NVRAM | PSD | PSD8xx | PSD9xx | PT1000 | RS232 | RTS | RXD | SPI | SRAM | TXD | Watchdogs | XIRQ

hc11e9.h Copyright

Hi! This may seem a strange request but the IP folk in Australian Universities are getting very precious. I run two courses here at Deakin Uni. based around the M...

EVBU HC11E9 Memory   [8 Articles]

Hi there, I have an evaluation board of a HC11E9 and it has 512bytes of ram & eeprom. However this board has a buffalo monitor program burnt in it. And I writin...

HC11E9 production programmer   [4 Articles]

Group; What commercial productin programmers are available for the HC711E9? TIA Dennis [Non-text portions of this message have been removed]...

Re: HC11 with Ethernet

--- In , BobGardner@a... wrote: > In a message dated 1/25/04 8:40:49 PM Eastern Standard Time, > kevin_jing_qiu@y... writes: > > Have anyone of you guys ever ...

Axman hc11e9-evbu   [4 Articles]

I wrote a program in C (ICC11) on the 68hc11e9-evbu. I run and rested the board about 20 times and every time the code was working fine. after about 20 times I could not run the ...

SCI interrupt stops PORTD   [3 Articles]

Hi all, I'm using HC11e9 and I have a code that uses PORTD (pin2-pin5). When I added the SCI code, especially SCCR2=0x24; (I'm only receiving), The entire port will not work. ...

HC11E9 Windowed parts, UV Erasable, PLCC

I asked the representative at Newark if she could find any E9 windowed parts, UV eraseable. These parts are discontinued. Only OTPs (one time programmable, crash and...

EXTERNAL FLASH EEPROM PROGRAMMING   [3 Articles]

Hello everyone. I've got a problem that I've been trying to figure out for some time now, and I have yet to find good information regarding the topic. I'm trying to program an...

68HC11E9 - Usable Memory for Programming?   [4 Articles]

Hello all, I am using an HC11EVBU2 board with an HC11E9 chip on it, and it also appears to have some external memory on the board as well. I'm trying to find room to write cod...

problem with time program   [4 Articles]

I have the following program loaded on a Adapt11C24DXEVB Module which uses the hc11e9 microcontroller. I am trying to output a clock signal on OC4. However, no ma...

Re: Interfacing

I use also the 'E9 to scan two, 4 x 4 matrix keypads using the SPI interface. My keypads are of the "crossbar" matrix type. Pressing a key connects one column ...