27c256 | 4K81H | 68HC11A1 | 68HC11P1 | 68hc24 | 68HC711E9 | 68HC811 | 8255 | A2D | ADC | ADC12138 | Am85C30 | BRCLR | Buffalo | CMOS | EEPROM | EPROM | Ethernet | EVB | EVBU | HC11E1 | HC11E9 | HC711E9 | Horray | ImageCraft | IRQ | Keypad | LCD | MC68HC11D0FN | MC68HC11E1CFU3 | MC68HC11F1 | MC68HC711E9 | MC68HC711E9CFN2 | Microcore11 | Microstamp11 | Minikit | NVRAM | PSD | PSD8xx | PSD9xx | PT1000 | RS232 | RTS | RXD | SPI | SRAM | TXD | Watchdogs | XIRQ

Hit the Enter (carriage return) key. Emmett Redd Ph.D. mailto: Associate Professor (417)836-5221 Department of Physics, Astronomy, and Materials Science Southwest Missouri State University Fax (417)836-6226 901 SOUTH NATIONAL Dept (417)836-5131 SPRINGFIELD, MO 65804 USA > -----Original Message----- > From: aporaria [mailto:] > Sent: Friday, March 19, 2004 12:49 PM > To: > Subject: [m68HC11] Buffalo: no command prompt ">"? > > I am trying to get an old M68HC11Evb running again using the BUFFALO > firmware that came with it. > The problem is that after power up or reset I do get the > > "BUFFALO 2.5 (ext) - Bit User Fast Friendly Aid to Logical > Operation" > message, but not the monitor command prompt ">". > I am using a W2K box to communicate with the EVB. > Any Ideas? > Thanks. > > > ------------------------ Yahoo! Groups Sponsor > Yahoo! Groups Links

(You need to be a member of m68hc11 -- send a blank email to m68hc11-subscribe@yahoogroups.com )