Thanks to all again for the input on my most recent prototype. I
modified an ooPIC-R to run 6 Sharp GP2YOA700K sensors. I made 2
additional A2D pins availble by removing the on-board LEDs and added
some extra cooling to the VR.

Here is is:

http://tech.ph.groups.yahoo.com/group/oopic/photos/view/650e?b=1
------------------------------------



(You need to be a member of oopic -- send a blank email to oopic-subscribe@yahoogroups.com )

--- In o...@yahoogroups.com, "design.wonk" wrote:
>
> Thanks to all again for the input on my most recent prototype. I
> modified an ooPIC-R to run 6 Sharp GP2YOA700K sensors. I made 2
> additional A2D pins availble by removing the on-board LEDs and added
> some extra cooling to the VR.
>
> Here is is:
>
> http://tech.ph.groups.yahoo.com/group/oopic/photos/view/650e?b=1
>

Does the VR get hot?

Richard

------------------------------------



(You need to be a member of oopic -- send a blank email to oopic-subscribe@yahoogroups.com )

I was advised to add it if running 3A through the VR. Figured it
wouldn't hurt. I am waiting for additional sensors for a full-scale
test, but all A2D lines check out OK.

--- In o...@yahoogroups.com, "rtstofer" wrote:
>
> --- In o...@yahoogroups.com, "design.wonk" wrote:
> >
> > Thanks to all again for the input on my most recent prototype. I
> > modified an ooPIC-R to run 6 Sharp GP2YOA700K sensors. I made 2
> > additional A2D pins availble by removing the on-board LEDs and added
> > some extra cooling to the VR.
> >
> > Here is is:
> >
> > http://tech.ph.groups.yahoo.com/group/oopic/photos/view/650e?b=1
> > Does the VR get hot?
>
> Richard
>

------------------------------------



(You need to be a member of oopic -- send a blank email to oopic-subscribe@yahoogroups.com )