I use PicBasic Pro on this chip with ICProg. I am trying not to use an external xtal on it. Does anyone know how to set it...

I use PicBasic Pro on this chip with ICProg. I am trying not to use an external xtal on it. Does anyone know how to set it using PicBasic? Thanks Randy ----- Original Message ----- From: "itiseasy2000" Date: Tue, 28 Sep 2004 01:56:13 -0000 To: p...@yaho

Hi all, I've got an issue. My ICD-2 on MPLAB 6.60 says that the programmer won't support the 16F628. The MC website says it...

Hi all, I've got an issue. My ICD-2 on MPLAB 6.60 says that the programmer won't support the 16F628. The MC website says it will program it, but not debug it without an adapter. OK, since my IDE refuses to let me choose the ICD-2 as my programmer, it is obvious which way the w

I have some books on the way to learn PIC programming. I think that the demos in the books are all based on the 16F84. This part seems to be a...

I have some books on the way to learn PIC programming. I think that the demos in the books are all based on the 16F84. This part seems to be a bit long in the tooth and also expensive compared to more powerful chips. Would the 16F628A be a good substitute for working through the books??? or would some other chip be a better choice. When I run a small program on the simulator the output for...

Message Hello all,  

Message Hello all,  

Does anyone have or know of a source for good PID control code (written in C) for the PIC. I intend to do drive motor speed control...

Does anyone have or know of a source for good PID control code (written in C) for the PIC. I intend to do drive motor speed control with a 16F876A using the built-in PWM hardware. Thanks, BRW

Any recommendations for good PIC programming books? Also, are there any really lame books I should be sure to avoid? ...

Any recommendations for good PIC programming books? Also, are there any really lame books I should be sure to avoid?

Message Hello all,  

Message Hello all,  

Hi all, I have a program on a 16F83 that is reading motor CEFM, with many safeguards of course, that usually works swimmingly....

Hi all, I have a program on a 16F83 that is reading motor CEFM, with many safeguards of course, that usually works swimmingly. However, every so often I'll get a totally bogus error out of it, for instance: reading 24,25,25,-84,25,24... Huh? what is this called? I

I'm interested in using a 16F88 with a couple I2C devices and, looking through the PIC datasheet, it looks WAY more complicated...

I'm interested in using a 16F88 with a couple I2C devices and, looking through the PIC datasheet, it looks WAY more complicated than me just writing big-bang routines. Is there a simple example of using the onboard I2C interface or should I just write the simple big-bang ro

I have a program in my 16F88 that reads data from a GPS (through the hardware UART), stores it in RAM, parses it, and then writes...

I have a program in my 16F88 that reads data from a GPS (through the hardware UART), stores it in RAM, parses it, and then writes certain items to an external EEPROM. What I've discovered, though, is that I have to turn off continuous receive (CREN=0) before I do my processing ro