Sign in
Search piclist
Subscribe to piclist
piclist by Keywords
12F675 | 16F628 | 16F84 | 16f877 | 16F877A | 16F88 | 18F458 | ADC | AVR | Bootloader | CAN | CCS | CRC | EAGLE | EEPROM | ICD | ICSP | IDE | JDM | LED | Macros | Microchip | MPLAB | PCB-CAD | PIC10F | Pic12f675 | PIC16F84 | PIC16F84A | PIC16F877 | PIC18 | PIC18F452 | PicBasic | PICC | PICSTART | PWM | RS-485 | RS232 | SMT | SPI | UART | USART | USB | Wireless | Wisp628 | Xilinx
Ads
Discussion Groups
Discussion Groups | Piclist | 16F88 and CLKO on RA6
A discussion group for the PICMicro microcontroller. Also called the Microchip PIC, this list is dedicated to the use and abuse of this fine, simple, microcontroller. Close to topic posts are welcome, ie. general electronics.
16F88 and CLKO on RA6 - rtstofer - May 4 23:57:00 2005
Has anyone successfully sent Fosc/4 to RA6 when using the internal RC
oscillator at 8 MHz? I have tried a lot of combinations of Fosc and
_CONFIG1 but so far, no output.
I thought I did a pretty good job of reading the datasheet but still,
no output; I must have missed something.
(You need to be a member of piclist -- send a blank email to piclist-subscribe@yahoogroups.com )
oscillator at 8 MHz? I have tried a lot of combinations of Fosc and
_CONFIG1 but so far, no output.
I thought I did a pretty good job of reading the datasheet but still,
no output; I must have missed something.
(You need to be a member of piclist -- send a blank email to piclist-subscribe@yahoogroups.com )
Re: 16F88 and CLKO on RA6 - upand_at_them - May 5 7:53:00 2005
I'm just going through the datasheet. Sometimes an extra pair of eyes
helps...
Read the fuses back and make sure bits 4, 1, 0 are set to 1, 0, 1. And
you probably have to disable A/D with: CMCON=7, ANSEL=0.
Mike --- In piclist@picl..., "rtstofer" <rstofer@p...> wrote:
> Has anyone successfully sent Fosc/4 to RA6 when using the internal RC
> oscillator at 8 MHz? I have tried a lot of combinations of Fosc and
> _CONFIG1 but so far, no output.
>
> I thought I did a pretty good job of reading the datasheet but still,
> no output; I must have missed something.
(You need to be a member of piclist -- send a blank email to piclist-subscribe@yahoogroups.com )
helps...
Read the fuses back and make sure bits 4, 1, 0 are set to 1, 0, 1. And
you probably have to disable A/D with: CMCON=7, ANSEL=0.
Mike --- In piclist@picl..., "rtstofer" <rstofer@p...> wrote:
> Has anyone successfully sent Fosc/4 to RA6 when using the internal RC
> oscillator at 8 MHz? I have tried a lot of combinations of Fosc and
> _CONFIG1 but so far, no output.
>
> I thought I did a pretty good job of reading the datasheet but still,
> no output; I must have missed something.
(You need to be a member of piclist -- send a blank email to piclist-subscribe@yahoogroups.com )