Sign in
Search rabbit-semi
Subscribe to rabbit-semi
Ads
Discussion Groups
Rabbit-Semi
This is a group for folks designing and programming embedded systems using the Rabbit Semiconductor C-programmable microcontroller. Rabbit Semi is a spin-off from Z-World who makes a variety of embedded modules and tools. This group is not affiliated with either Rabbit or Z-World, but is a user forum for sharing ideas, asking questions, flaunting knowledge, and other typical user group stuff. The Rabbit is a powerful uC, supported by a full-featured C-compiler.
Re: BL2100 and SF1000
tech56 - Apr 7 2008
We have a SF1000 (SF1004, SF1008) working with a BL2100 board. We've
connected to some 'spare pins' and setup bit banging. That's just for
development. When the program has ... 
How to block or accept connection from specified ip or mac addresses?
Yanho - Apr 6 2008
Hi,
I have a simple listen tcp/ip port based on RCM3200.
I need to have a black (or white) list of IP (or MAC) addresses for incoming
connections to this port.
I'm unable t... Re: X's instead of buttons
dtriskel - Apr 4 2008
Maybe the rcm cannot server as requests as it is asked.
Try to increment HTTP_MAXSERVERS (maximum number of simultaneous http
requests you are serving).
You also have to ens... Re: SNMP Resources [2 Articles]
Steve Trigero - Apr 1 2008
I suppose a little of both, but at this point I'm trying to understand.
I've run the SNMP sample program in DC, and if you do an snmpwalk,
it gets all the parameters as adverti... Re: SNMP Resources
Dan Allen - Apr 1 2008
What are you trying to accomplish? Learning, or an implementation in mind?
Dan...
On Tue, Apr 1, 2008 at 2:02 PM, Steve Trigero wrote:
> Per Rabbit's recommendation,... Re: analog driving rabbit pins
eilidhs_daddy - Apr 1 2008
--- In r...@yahoogroups.com, "Marco" wrote:
>
> Has anyone tried to drive high or low an input pin of a rabbit with a
> transitor buffer? I mean just generating a voltage ... Reading Modbus Registers
whmeade2008 - Mar 29 2008
I have been able to write to registers over modbus and set/reset coils
but have not been able to figure out how to read a register or group
of registers. I am using the sample m... Re: Backdoor IP address
Bill_CT - Mar 28 2008
--- In r...@yahoogroups.com, Scott Henion wrote:
>
> I always use a UDP socket that accepts broadcasts. That way I can
> connect to it regardless of the IP address. I have... Re: Dynamic C library question
Alexandre Kremer - Mar 28 2008
Donīt ifdef, undef and define keywords canīt handle
this?
--- l...@gmail.com escreveu:
> Good Morning All,
>
> I want to retrieve error log info using the
> errlogG... RCM4010 Serial C Ooutput
whmeade2008 - Mar 27 2008
I am trying to transmit a simple string out serial port C on the
RCM4010 DEV board. I am using DC v10.21. I am new to Dynamic C but
have programmed for years in PICC for PIC ...