Sign in
Search rabbit-semi
Subscribe to rabbit-semi
Ads
Discussion Groups
Rabbit-Semi
This is a group for folks designing and programming embedded systems using the Rabbit Semiconductor C-programmable microcontroller. Rabbit Semi is a spin-off from Z-World who makes a variety of embedded modules and tools. This group is not affiliated with either Rabbit or Z-World, but is a user forum for sharing ideas, asking questions, flaunting knowledge, and other typical user group stuff. The Rabbit is a powerful uC, supported by a full-featured C-compiler.
udp_send problem [4 Articles]
allsoft01a - Jan 23 2008
I am trying to use upd_send to send data to another rabbit. I am using
RCM3315 cores, Dynamic C 9.25 and Ethereal thru a HUB to monitor
traffic. I am using UDP_CLI.C sample a... 
Robert Richter DLM and DC 9.21
Micron Engineering - Jan 23 2008
I am using Robert Richter DLM with an old DC 7.21; a my customer is
trying to compile some source code I did him (and also the same DLM)
with a DC 9.21. He said that with littl... RFU target programming sequence
formula_cpu - Jan 22 2008
Hi,
I am using the RCM4400W and DC10.21.
I have been using RFU to load the BIN file of my firmware. Now I am
trying to create the same capability on a microprocessor board I ... Fat module EDEVNOTREG error
"Kruit, Chris van der [FINT]" - Jan 22 2008
Hello,
I'm using a RCM3315 with a SD card connected via a serial port. For
software I use DC9.25, FAT module 212 and the module from SHDESIGN for
interfacing the SD card.
Now... Re : RCM2200, serial reading problem
Loris Boillet - Jan 21 2008
Thanks all,
it was finally a hardware problem that one of my others colleague found out. A termination resistor was missing around the 485 transceiver, and there was noise becau... connect a sensing device [5 Articles]
Antonio - Jan 19 2008
hi to all,
this is my first message here.
i'm writing my first code (and i'm using for the first time) for an
RCM2000 and i must chosse some device for inputs and outputs.
... RCM2200, serial reading problem [7 Articles]
Drink - Jan 17 2008
Hello,
I am trying to read characters (via RS-485 using a MAX1487 or a LMS1487
transceiver) through the serial port D (pin 3) of a RabbitCore RCM2200,
using Dynamic C 7.21 TSE... Change Default SERC_RXPORT to PEDR to enable PE3 instead of PC3 [2 Articles]
guillaume_lestriez - Jan 14 2008
Hello,
I'm currently using RCM4000 with analog & nandFlash. I'm trying to
organize my 4 serial ports as follows:
Serial A for programming or serial RS232 (first) --> PC6,PC7... How to use the PWM features of the RCM4010?
stugray99 - Jan 13 2008
I am a bit confused. I have the RCM4010 with proto board.
I have scanned the documentation and cannot find instructions on how to
use the built in PWM functions of the 4010.
... Quad read buffer [2 Articles]
Jason Hermance - Jan 12 2008
Can someone tell me what the size of the Qd_read buffer is?
Also does someone know what the max input frequency is on the
Quadrature input is?
Thank you
...