Sign in
Search rabbit-semi
Subscribe to rabbit-semi
Ads
Discussion Groups
Discussion Groups | Rabbit-Semi | Re: BL2100 and SF1000
This is a group for folks designing and programming embedded systems using the Rabbit Semiconductor C-programmable microcontroller. Rabbit Semi is a spin-off from Z-World who makes a variety of embedded modules and tools. This group is not affiliated with either Rabbit or Z-World, but is a user forum for sharing ideas, asking questions, flaunting knowledge, and other typical user group stuff. The Rabbit is a powerful uC, supported by a full-featured C-compiler.
Re: BL2100 and SF1000 - tech56 - Apr 7 23:01:40 2008
We have a SF1000 (SF1004, SF1008) working with a BL2100 board. We've
connected to some 'spare pins' and setup bit banging. That's just for
development. When the program has been developed we can change to the
programming port by changing some #defines and it will run considerably
faster.
The pins we connected to are:
Name - Rabbit Pin - SF1000
Rx - PD7 - SER_OUT
Tx - PD6 - SER_IN
Clk - PD2 - SER_CLK
CS - PB6 - /CS
If you email us we can send you the test harness we wrote to confirm the
SF1000 can be connected to the BL2100. It initialises the SF1000, and then
writes and reads a block of data to confirm the SF1000 is working.
Paul
Bear Technologies
www.beartech.com.au
reyahabd wrote:
>
> I am trying to connect SF1000 flash to BL2100. I am planning to use
> serial port B. So what D/I pins and setting I should be using? I am
> only using ADC0 , ADC1, IN00 and IN01.
>
--
View this message in context: http://www.nabble.com/BL2100-and-SF1000-tp1880714p16546003.html
Sent from the Rabbit Semiconductor mailing list archive at Nabble.com.
------------------------------------
(You need to be a member of rabbit-semi -- send a blank email to rabbit-semi-subscribe@yahoogroups.com )