Sign in
Search rabbit-semi
Subscribe to rabbit-semi
Ads
Discussion Groups
Discussion Groups | Rabbit-Semi | rabbit 3365
This is a group for folks designing and programming embedded systems using the Rabbit Semiconductor C-programmable microcontroller. Rabbit Semi is a spin-off from Z-World who makes a variety of embedded modules and tools. This group is not affiliated with either Rabbit or Z-World, but is a user forum for sharing ideas, asking questions, flaunting knowledge, and other typical user group stuff. The Rabbit is a powerful uC, supported by a full-featured C-compiler.
rabbit 3365 - Enrico Hofmann - Apr 30 10:33:10 2008
hi i get the following lines....
what happens with the digi modul....
greeting
enrico hofmann
line 33 : WARNING BOARDTYPES.LIB : No ID Block found on the
target; defining _BOARD_TYPE_ to be a BL1810.
line 270 : ERROR BOARDTYPES.LIB : Compile mode 'Code and BIOS in
flash, run in RAM' not supported for this board.
line 805 : ERROR UTIL.LIB : _TOS_WATCH_MEM is out of scope/ not
declared.
line 1 : WARNING Rabbitbios.c : Origin xmemcode collides with
origin watcode starting at physical address 0xcc00.
------------------------------------
(You need to be a member of rabbit-semi -- send a blank email to rabbit-semi-subscribe@yahoogroups.com )
what happens with the digi modul....
greeting
enrico hofmann
line 33 : WARNING BOARDTYPES.LIB : No ID Block found on the
target; defining _BOARD_TYPE_ to be a BL1810.
line 270 : ERROR BOARDTYPES.LIB : Compile mode 'Code and BIOS in
flash, run in RAM' not supported for this board.
line 805 : ERROR UTIL.LIB : _TOS_WATCH_MEM is out of scope/ not
declared.
line 1 : WARNING Rabbitbios.c : Origin xmemcode collides with
origin watcode starting at physical address 0xcc00.
------------------------------------
(You need to be a member of rabbit-semi -- send a blank email to rabbit-semi-subscribe@yahoogroups.com )