Sign in
Search rabbit-semi
Subscribe to rabbit-semi
Ads
Discussion Groups
Discussion Groups | Rabbit-Semi | Require Small program to test functionality of RC servo_lib
This is a group for folks designing and programming embedded systems using the Rabbit Semiconductor C-programmable microcontroller. Rabbit Semi is a spin-off from Z-World who makes a variety of embedded modules and tools. This group is not affiliated with either Rabbit or Z-World, but is a user forum for sharing ideas, asking questions, flaunting knowledge, and other typical user group stuff. The Rabbit is a powerful uC, supported by a full-featured C-compiler.
Require Small program to test functionality of RC servo_lib - mountainhero - Aug 29 8:03:09 2008
I am making a RCM 2000 based controller for Futaba S3003(Model=20
Torque Angle Pulse width =3DFutaba S3003 0.32 N=B7m 180=B0 0.5ms=962.1ms )=
=20
servos.
Till now I have done the following till now with help from folks on=20
the web=20
1.Copied RC Servo_lib in the Rabbit library folder.
2.Given 5 volts to the servo RED, and GND to servo BLACK
3.Linked the GND of RCM 2000 supply and Futaba servo supply
4.The WHITE terminal of Servo is free with me for connecting to=20
one of the I/O pins of RCM 2000
Now I am stuck and I need help to proceed furher...........Since the=20
RC_Servo_lib is exclusively a library file and needs a program to=20
access this library's functionality; I need few lines of code or a=20
small Dynamic C Program which can be compiled to RCM 2000 and it=20
moves the rotor of the servo back and forth, or in small Steps.
............
m...@yahoo.com
------------------------------------
(You need to be a member of rabbit-semi -- send a blank email to rabbit-semi-subscribe@yahoogroups.com )
Torque Angle Pulse width =3DFutaba S3003 0.32 N=B7m 180=B0 0.5ms=962.1ms )=
=20
servos.
Till now I have done the following till now with help from folks on=20
the web=20
1.Copied RC Servo_lib in the Rabbit library folder.
2.Given 5 volts to the servo RED, and GND to servo BLACK
3.Linked the GND of RCM 2000 supply and Futaba servo supply
4.The WHITE terminal of Servo is free with me for connecting to=20
one of the I/O pins of RCM 2000
Now I am stuck and I need help to proceed furher...........Since the=20
RC_Servo_lib is exclusively a library file and needs a program to=20
access this library's functionality; I need few lines of code or a=20
small Dynamic C Program which can be compiled to RCM 2000 and it=20
moves the rotor of the servo back and forth, or in small Steps.
............
m...@yahoo.com
------------------------------------
(You need to be a member of rabbit-semi -- send a blank email to rabbit-semi-subscribe@yahoogroups.com )