It's been a few months since the launch of the new forums.  Here are a few thoughts. The thumbsup and beer buttons    If there is one thing that could have a...

Hello.I would like some advice on good implementation strategies/general practices for C, 8bit micro.for example i have in one of my project a functions that ramps...

Hi there -- sorry to bug you with a newbie question, but I'm a hardware design engineer, so software sometimes leaves me a bit confused.Can you take a quick glance...

We use Openwrt 18.06 for a LinkIt Smart 7688 development board. We use the latest mt76 open source wifi driver for an embedded mt7603 wifi IC. It's possible to use...

Hi everyone, I’m working in a young biotech company developing a scientific instrument for supporting its technology. I contact you on this forum for having your...

Hello,I have been developing a C language software for software oscilloscope which is part of a control software. From timing point of view the software consists...

I have STM8 based hardware design. But I am not able to decide what interface I should  expose to program it with Arduino. It has UART, SPI, etc interfaces.What...

I need to cross compile c++ code for an embedded device with the specs shown below with hardware float operations support. Cross compiling from Ubuntu 20.04 without...

Our application is Advanced Drive Assist Systems(ADAS). Our Electronic Control Unit(ECU) contains Two Renesas RH850 / U2A16 Microcontrollers. Each microcontroller...

Hi chaps and chapesses -- sorry to bug you again -- this is a follow-on to my previous question: What size variables are best for 8-bit, 16-bit, and 32-bit MCUs?...