Rotomotion Gyro and accelerometer 2 DOF

Started by kjellosan in BasicX13 years ago 6 replies

Hi there I am trying to read the signals from the Z board of the rotomotion part. It is an accelerometer and a gyro. I...

Hi there I am trying to read the signals from the Z board of the rotomotion part. It is an accelerometer and a gyro. I connect this board's pins directly to ADC pins on my BX24. My problem is that the signals I get doesn't vary when I move the Gyro/Accelerometer. I h


Re: code timing (was ADC sampling)

Started by npoz0 in BasicX12 years ago 4 replies

Hey Tom, Thank you for your help and suggestions. I took out the ascii conversion. and I'm currently using this code to write to my...

Hey Tom, Thank you for your help and suggestions. I took out the ascii conversion. and I'm currently using this code to write to my sdcard: Do Until (GetPin(8) = 0) ADCdata(0) = GetADC(14) ADCData(1) = GetADC(15) Call PutQueue(OutputQueue, ADCdata(0),2) Call PutQueueStr(OutputQueue, ",") Call PutQueue(OutputQueue, ADCdata(1),2) Call PutQueueStr(OutputQueue