LCDX backlight flicker during I/O

Started by jstjohnz in BasicX15 years ago 2 replies

Hello, This is my first experience with BasicX. I am using the LCDX, essentially a BasicX-35 coupled to a 4x20 LCD. This unit has a 4x4 ...

Hello, This is my first experience with BasicX. I am using the LCDX, essentially a BasicX-35 coupled to a 4x20 LCD. This unit has a 4x4 keypad interface, 8 analog inputs, and 8 built-in relay drivers, driven from a chip that interfaces to the BasicX with SPI. Whenever I do a "relayout" command to control a relay bit I get a momentary


suggest connectors for LCDX?

Started by donnpenny in BasicX9 years ago 1 reply

I recently purchased the LCDX with Development Kit. Would someone suggest a 4 pin connector with attached wires for the Analog 6, 7, 8 Inputs...

I recently purchased the LCDX with Development Kit. Would someone suggest a 4 pin connector with attached wires for the Analog 6, 7, 8 Inputs and Gnd? Also a 16 pin connector with attached wires for the Keypad Inputs and SPI Interface? Thank you. ------------------------------------