Gary Peek skrev:
> Perhaps I'm merely having a "bad documentation day", but I'm
> having problems figuring out how to program the Cypress series
> of chips that contains the CY7C63310 and CY7C63801.
> 
> Their datasheet says: "The enCoRe II supports in system programming
> by using the D+ and D� pins as the serial programming mode interface.
> The programming protocol is not USB."
> 
> This seems to imply that they have a utility program on their web
> site for that purpose but I can't find it.

If you just need the programming software, try looking for "PSoC 
programmer" or "PSoC Designer" or just "PSoC".

http://app.cypress.com/portal/server.pt?space=CommunityPage&control=SetCommunity&CommunityID=285&PageID=552&shortlink=SD1099

Perhaps I'm merely having a "bad documentation day", but I'm
having problems figuring out how to program the Cypress series
of chips that contains the CY7C63310 and CY7C63801.

Their datasheet says: "The enCoRe II supports in system programming
by using the D+ and D� pins as the serial programming mode interface.
The programming protocol is not USB."

This seems to imply that they have a utility program on their web
site for that purpose but I can't find it.

I see where there is a CY3655 development board but it is rather
expensive and I would prefer to avoid that.

Can anyone who has begun using this series of chips give me any
advice or tips on getting started?