Reply by moon August 20, 20092009-08-20
Iam using XPS 8.2i.I have built a custom peripheral and attached it to
MicroBlaze (v 5.0) via OPB bus.My peripheral generates the two
interrupts.These interrupts pins are input to the interrupt controller
INTC (1.00 c).
Initially both interrupts are disabled.Then only high priority
interrupt is enabled.
What my objective is that when a high priority interrupt occurs:in its
ISR it should disabled itself and enabled the other interrupt on
interrupt controller.
But actually what is happening that when high priority interrupt is
occurred it goes into its ISR and it doesnot disable itself.the other
interrupt is enabled and the microblaze is stuck in handling both the
Any help in this regard is welcomed!