Reply by Vladimir Vassilevsky●October 11, 20092009-10-11
ejkrohne wrote:
> I've been in the embedded area for quite some time. I am currently running
> DSP/BIOS on a TI F2801.
>
> I am having trouble accessing an EEPROM over I2C.
Don't use DSP/BIOS. Control the hardware by your own.
> I saw a thread that mentioned a DSP/BIOS driver for I2C and was wondering
> if I could get the source to modify for my application.
> I need to be able to write and/or read n bytes to/from any address in the
> EEPROM.
Read the EEPROM datasheet, read the 21xx manual, write 20 lines of code.
Vladimir Vassilevsky
DSP and Mixed Signal Design Consultant
http://www.abvolt.com
Reply by ejkrohne●October 9, 20092009-10-09
I've been in the embedded area for quite some time. I am currently running
DSP/BIOS on a TI F2801.
I am having trouble accessing an EEPROM over I2C.
I saw a thread that mentioned a DSP/BIOS driver for I2C and was wondering
if I could get the source to modify for my application.
I need to be able to write and/or read n bytes to/from any address in the
EEPROM.
---------------------------------------
This message was sent using the comp.arch.embedded web interface on
http://www.EmbeddedRelated.com