Reply by usa_jian_yang ●July 27, 20042004-07-27
Hi everyone;

I got 2 Axiom 68HC11 CMD11E1 boards used by other guys before. But
Buffalo Monitor cannot work.

I install AxIDE on windows XP. set serial port option: 9600, N, 8,
1, off, off, off. When I reset the board and press enter key , I can
see the cusor _ moves forward and goes to new line, but no Message "
BUFFALO 3.4AX - Axion version of the Motorola Monitor /Debugger".
I check all Jumpers and power.

One guy told me that I should upload buf34x.s19 to board. I set
Jumper 1, 2 and 10 on and select " program EEPROM (Flash or
External)" and click ok. After I reset the board, execut bootloader,
the error message report "Bootloader code wasn't executed".

I want configure the board, but it report the same error "Bootloader
code wasn't executed".

Do you think the hardware has problem?

Thanks

Jian