Reply by "David A. Perreault"●October 8, 20102010-10-08
You should also check your program to make sure it is not branching
somewhere and executing data which looks like a SWI instruction.
Dave
Thomas Hoks wrote: >
> Thanks
>
> There is a SWI command in the program, but it did not change any thing
> when I removed it
>
> Still working on it.
>
> --- On Wed, 10/6/10, justin lucas
> > wrote:
>
> From: justin lucas
> >
> Subject: RE: [68HC12] Dragon 12 Plus
> To: 6...
'
'
Reply by Thomas Hoks●October 7, 20102010-10-07
Thanks
There is a SWI command in the program, but it did not change any thing when I
removed it
Still working on it.
--- On Wed, 10/6/10, justin lucas wrote:
From: justin lucas
Subject: RE: [68HC12] Dragon 12 Plus
To: 6...
Date: Wednesday, October 6, 2010, 8:01 PM
Its been awhile since I have programmed, but it usually means the programmer has
inserted a break point. In assembly, I think the command is "SWI", but
don't know for sure. I would check your code to see where you have
inserted a break point
Good luck
To: 6...
From: t...@yahoo.com
Date: Wed, 6 Oct 2010 02:31:29 +0000
Subject: [68HC12] Dragon 12 Plus
I'm a new user student. Trying to learn this. I am getting a error
message When trying to run a program to run the 4X4 key pad with the 7 digit
display.
It say "User Bkpt encountered". I cannot find any thing that can tell me what
is wrong.
Any one know what I need to do to correct
Thanks
Reply by justin lucas●October 6, 20102010-10-06
Its been awhile since I have programmed, but it usually means the programmer has
inserted a break point. In assembly, I think the command is "SWI", but
don't know for sure. I would check your code to see where you have
inserted a break point
Good luck
To: 6...
From: t...@yahoo.com
Date: Wed, 6 Oct 2010 02:31:29 +0000
Subject: [68HC12] Dragon 12 Plus
I'm a new user student. Trying to learn this. I am getting a error
message When trying to run a program to run the 4X4 key pad with the 7 digit
display.
It say "User Bkpt encountered". I cannot find any thing that can tell me what
is wrong.
Any one know what I need to do to correct
Thanks
Reply by Thomas●October 5, 20102010-10-05
I'm a new user student. Trying to learn this. I am getting a error
message When trying to run a program to run the 4X4 key pad with the 7 digit
display.
It say "User Bkpt encountered". I cannot find any thing that can tell me what
is wrong.