Reply by Herbert Demmel October 11, 20062006-10-11
Hi,

I'm trying to use P1.24 of a LPC2214 as an output but the port pins
constantly remains at about 2.3V.

I'm using

IO1DIR |= (1 << 25);
IO1CLR = (1 << 25);

to pull the pin low (PINSEL2 bit 3 has the correct state, P1.20 is not
pulled low at reset). If I try to do the same with e.g. P1.16, everything
works as expected.

Any idea?

Regards
Herbert

An Engineer's Guide to the LPC2100 Series