Did Pin function Select register 2 (PINSEL2), bit 2, were celar?
"2 GPIO/DEBUG 0 Pins P1.36-26 are used as GPIO pins."
See also this note below:
"Note: LOW on this pin (P1.26) while RESET is LOW enables pins P1.31:26 to
operate as Debug port after reset"
"21.5 Reset state of multiplexed pins
On the LPC2131/2/4/6/8, the pins above are multiplexed with P1.31-26. To
have them
come up as a Debug port, connect a weak bias resistor (4.7-10 k depending
on the
external JTAG circuitry) between VSS and the P1.26/RTCK pin. To have them
come up as
GPIO pins, do not connect a bias resistor, and ensure that any external
driver connected
to P1.26/RTCK is either driving high, or is in high-impedance state, during
Reset."
Maybe it can help you.
;)
On 01/12/06, Michal Krestan wrote:
>
> Hi All,
>
> does anybody have idea, how to set pins P1.28-P1.31 as outputs on LPC2138?
> I've got at IODIR1=0xFFFF0000 and for
> example P1.26 works well as output, but still no success between P1.28 and
> P1.31.
>
> Michal
>
>
>
--
Thiago Pinheiro Felix da Silva e Lima
Engenheiro