"pxhoberman" said: > It is really a drag that the BX24 doesn't seem to be
able to set up a single line for serial... I'm desperate...
What did you find?
Reply by Tom Becker●April 25, 20072007-04-25
> So is there any way to get the BX24p to deal with
bytes coming back on the output pin?  - anything so the BX doesn't hang.
The BX-24 has no idea that there is data trying to arrive on a COM3
output pin, so I suspect that is not what causes your hang. You
should be able to define COM3 using pin zero for input, send the speed
change command to the PSC, change the COM3 speed (which will not run
at 38k4, BTW; 19k2 max), and fire away blindly at the PSC.
If you are hanging, it is not due to incoming data.
Reply by pxhoberman●April 24, 20072007-04-24
I've inherited a project in which I have to use a BX24p to control some servos
Parallax Servo Controller Rev B (PSC-B).
The PSC-B's default baud rate of 2400 is much too slow for the project, and I
need to take
advantage of the 'runtime selectable baud rate' to switch it to 38K4.
My problem is that the PSC-B is operated with a single pin for serial I/O and
defines COM3 with one pin for input, another for output.
I can easily run the PSC at 2400 baud, because it uses only output, and the
send anything back on the output pin.
However, changing the baud rate with an SBR command, causes the PSC-B to send a
confirmation message back on the serial line. (This is true of other PSC-B
VER? to verify and RSP to report).
So when I try to change the baud rate, my BX24p hangs, which I assume is the
result of the
PSC-B sending bytes back on the same pin.
I've tried parsing these bytes as input, but nothing seems to work, which I
because there's no way for the BSX24p to define single pin as both serial input
simultaneously. (I've also tried defining COM3 with both buffers set to the same
but this doesn't work either).
So is there any way to get the BX24p to deal with bytes coming back on the
output pin? I
don't need to read them, I could just flush them out - anything so the BX
Or, conversely, is there any way to set the PSC-B to boot up with the 38K4 baud
that I don't have to send the initial message? to set the baud rate?
It is really a drag that the PSC-B can't be changed with a simple jumper pin
It is really a drag that the BX24 doesn't seem to be able to set up a single
line for serial I/