> Did you check the clock and divider. Can it actually go that fast?
If so
> I assume you are going to deal with the speed issues. Anyway Post
the
> Question at WWW.8052.com . You might find an answer.
Hi Neil,
I am thinking of doing like f/16 (mode 2) using 20 MHz cystal. It will
give something more than 1mbps. Do I miss something here?
Thanks, I will post the Qs in the 8052.com.
PS
Reply by Neil Kurzman●February 7, 20052005-02-07
Prem wrote:
> Hi Dan,
> Thanks, I have also not used this device. This is special architecture
> and not many emulators support this. That is why I also wanted to
> know...I will let you know once I start working with the device.
> PS
Did you check the clock and divider. Can it actually go that fast? If so
I assume you are going to deal with the speed issues. Anyway Post the
Question at WWW.8052.com . You might find an answer.
Reply by Prem●February 5, 20052005-02-05
Hi Dan,
Thanks, I have also not used this device. This is special architecture
and not many emulators support this. That is why I also wanted to
know...I will let you know once I start working with the device.
PS
Reply by Dan Henry●February 4, 20052005-02-04
"Prem" <prem.sivasamy@gmail.com> wrote:
>Hi Experts,
>I am looking for some UART driver resources as I work on Dallas
>DS89C450 chip? I need to work with >1mbps in the serial interface? Any
>help would be appreciated..Thanks again
>PS
Oh my, that's pretty fast! You didn't say whether those should be
assembly language or C language driver resources, but at that speed, I
would suppose that you'd be polling regardless, in which case, I think
one of the UART polling routines likely to be found on your language
toolchain vendor's website should be adequate. I have not used that
particular Dallas device, so correct me if I am wrong or if there is
something unique about it compared to the other Dallas 8051 derivative
UARTs (which I *have* used).
--
Dan Henry
Reply by Prem●February 4, 20052005-02-04
Hi Experts,
I am looking for some UART driver resources as I work on Dallas
DS89C450 chip? I need to work with >1mbps in the serial interface? Any
help would be appreciated..Thanks again
PS