--- In l..., "derbaier" wrote: >
> --- In l..., "wilnfl" wrote:
> >
> > I use LPC2468.
> >
> > I has write some code to control PWM, and I set the PCON = 0x2, so the > > system enter power down mode, and then, I
cann't download any program > > to this chip, because every time this board power
up, it enter power > > down mode, so I cann't connect jtag. Anybody
has any method to solve > > this problem?
> >
> > Thanks in advacne.
> > Pull P2.10 low, and do a hard reset to force the bootloader to remain > in control after reset. That way, your code will not
execute and put > the chip into Power Down mode.
>
> --Dave
>
One option is erase the device via Serial using the Flash Magic.
Regards
Cesar de Almeida
2007/6/18, wilnfl : >
> --- In l... , "wilnfl"
> wrote:
> >
> > I use LPC2468.
> >
> > I has write some code to control PWM, and I set the PCON = 0x2, so
> the
> > system enter power down mode, and then, I cann't download any
program
> > to this chip, because every time this board power up, it enter power
> > down mode, so I cann't connect jtag. Anybody has any method to solve
> > this problem?
> >
> > Thanks in advacne.
> > I am sorry, I can not download the program to MCU.
>
Reply by derbaier●June 18, 20072007-06-18
--- In l..., "wilnfl" wrote: >
> I use LPC2468.
>
> I has write some code to control PWM, and I set the PCON = 0x2, so the
> system enter power down mode, and then, I cann't download any program
> to this chip, because every time this board power up, it enter power
> down mode, so I cann't connect jtag. Anybody has any method to solve
> this problem?
>
> Thanks in advacne.
>
Pull P2.10 low, and do a hard reset to force the bootloader to remain
in control after reset. That way, your code will not execute and put
the chip into Power Down mode.
--Dave
Reply by wilnfl●June 18, 20072007-06-18
--- In l..., "wilnfl" wrote: >
> I use LPC2468.
>
> I has write some code to control PWM, and I set the PCON = 0x2, so the > system enter power down mode, and then, I cann't
download any program
> to this chip, because every time this board power up, it enter power
> down mode, so I cann't connect jtag. Anybody has any method to solve
> this problem?
>
> Thanks in advacne.
>
I am sorry, I can not download the program to MCU.
Reply by wilnfl●June 18, 20072007-06-18
I use LPC2468.
I has write some code to control PWM, and I set the PCON = 0x2, so the
system enter power down mode, and then, I cann't download any program
to this chip, because every time this board power up, it enter power
down mode, so I cann't connect jtag. Anybody has any method to solve
this problem?