After finding some I2c Port Expanding ICs I decided to keep with the I2C but no
using master/slave multi processor communicaction .
I did many tests with 2 avr trying to figure it out how to transfer data
between them. I have no quit yet doing this but I will try it later.
Regards,
Edwin
--- In a..., "interruptcom" wrote: > See Atmel web site and saerch for smbus
communication.
> that's all you need.
> --- In a..., dmarte wrote:
> >
> > I need some sample code on how to implement a multi master o multi processor
communication either on synchronous serial communication or I2C bus.
> >
> > I have tried with I2C and I can read and write to eeprom devices
successfully. I don't know or haven't been able to communicate 2 o
more AVR controllers.
> >
> > The MCPM mode in the other hand is not clear enough in the datasheet.
Besides I haven't found any sample code about communication using this
protocol.
> >
> > I appreciate if you could give me any working piece of code or links to i
for this.
> >
> > Best Regards,
> > Edwin
>
Reply by interruptcom●October 26, 20092009-10-26
See Atmel web site and saerch for smbus communication.
that's all you need.
--- In a..., dmarte wrote: >
> I need some sample code on how to implement a multi master o multi processor
communication either on synchronous serial communication or I2C bus.
>
> I have tried with I2C and I can read and write to eeprom devices successfully.
I don't know or haven't been able to communicate 2 o more AVR
controllers.
>
> The MCPM mode in the other hand is not clear enough in the datasheet. Besides
I haven't found any sample code about communication using this protocol.
>
> I appreciate if you could give me any working piece of code or links to i for
this.
>
> Best Regards,
> Edwin
>
Reply by dmarte●October 22, 20092009-10-22
I need some sample code on how to implement a multi master o multi processor
communication either on synchronous serial communication or I2C bus.
I have tried with I2C and I can read and write to eeprom devices successfully. I
don't know or haven't been able to communicate 2 o more AVR
controllers.
The MCPM mode in the other hand is not clear enough in the datasheet. Besides I
haven't found any sample code about communication using this protocol.
I appreciate if you could give me any working piece of code or links to i for
this.