On Thu, 26 May 2005 08:37:53 -0500, elsaximena <xrodriguezp@etb.net.co> 
wrote:

> [...] but I connect a
> GP2D12 infrarred sensor to the UART and I use the hyperterminal for see 
> the
> output of the sensor [...]

GP2D12 produces analog signal.  You probably need to connect it to one of 
ADC inputs?

   Vadim

In article <WLidnbyCU_msTAjfRVn_vA@giganews.com>, elsaximena 
<xrodriguezp@etb.net.co> writes
>HI...
>
>I am programming with a MAVRIC II that uses the ATMEGA 128 but I 
>connect a
>GP2D12 infrarred sensor to the UART and I use the hyperterminal for see 
>the
>output of the sensor but the only thing that I receive was:
>&#4294967295;&#4294967295;@}@@wp@}@pNstr@&#4294967295;&#4294967295;&#4294967295;&#4294967295;&#4294967295;xw@&#4294967295;&#4294967295;&#4294967295;&#4294967295;&#4294967295;
>
>What can I do??? The same thing happened with the srf04 ultrasonic
>sensor!!!
>
either
a) the baud rate is not correct
or
b) one end is set to 8 bit and one is set to 9 bit
-- 
Tim Mitchell

HI...

I am programming with a MAVRIC II that uses the ATMEGA 128 but I connect 
GP2D12 infrarred sensor to the UART and I use the hyperterminal for see th
output of the sensor but the only thing that I receive was:
&#4294967295;&#4294967295;@}@@wp@}@pNstr@&#4294967295;&#4294967295;&#4294967295;&#4294967295;&#4294967295;xw@&#4294967295;&#4294967295;&#4294967295;&#4294967295;&#4294967295;

What can I do??? The same thing happened with the srf04 ultrasoni
sensor!!!

I appreciate any help

Thanks


		
This message was sent using the comp.arch.embedded web interface o
www.EmbeddedRelated.com