Reply by mjames_doveridge●March 20, 20082008-03-20
--- In l..., "azhong_0810" wrote: >
> hi all..i need some advices and helps here..
> i am using lpc2129 and i can flash the program into the board before
> this, but it just all the sudden that my board cannot communicate with
> my pc..did anyone has experience like this before?can give me some
> suggestions?is it the problems of my pc or the board itself?
> i had tried to replace the RS232,MAX232 IC and the serial cable but
> the board still cannot communicate with my pc.
>
> i connect the board to my pc using serial cable and lpc2000 Flash Utility. > hope to hear from u guys soon..cause this is kinda
emergency..thanks!!
>
It's RS232, so it's guaranteed to be a PITA. It's even more
complex
than usual if you are using the RS232 control lines to operate the
'P0.14' ISR bootloader start and the processor reset line. You
really
need a scope to check what's happening along the chain.
Is the PC operating the control lines correctly?
Are these signals correctly arriving at P0.14 and the reset line?
hi all..i need some advices and helps here..
i am using lpc2129 and i can flash the program into the board before
this, but it just all the sudden that my board cannot communicate with
my pc..did anyone has experience like this before?can give me some
suggestions?is it the problems of my pc or the board itself?
i had tried to replace the RS232,MAX232 IC and the serial cable but
the board still cannot communicate with my pc.
i connect the board to my pc using serial cable and lpc2000 Flash Utility.
hope to hear from u guys soon..cause this is kinda emergency..thanks!!
=======================================================================Groups
related to lpc2000
=======================================================================
msp430 (388 common members) http://groups.yahoo.com/group/msp430?v=1&t=ipt&ch=email&pub=groups&slktr0&sec=recg
Computers & Internet/Hardware: Welcome to the MSP430 User's Group! The
purpose of...