--- In l..., "ksdoubleshooter" wrote: >
> If you used the default startup file that Crossworks uses, then it set
> up the PLL.
>
> Jeff
>
> --- In l..., "richdinoso" wrote:
> >
> > When I enter main, bits 4:0 of PLL0CFG = 4 (those are the MSEL bits).
> > I was curious why this is the case, because page 30 of the user
> manual
> > says the reset value for the MSEL bits = 0.
> >
> > Is MSEL being changed before main? I'm using the Crossworks
compiler.
> >
> > --- Rich
>
Reply by ksdoubleshooter●October 31, 20082008-10-31
If you used the default startup file that Crossworks uses, then it set
up the PLL.
Jeff
--- In l..., "richdinoso" wrote: >
> When I enter main, bits 4:0 of PLL0CFG = 4 (those are the MSEL bits).
> I was curious why this is the case, because page 30 of the user manual > says the reset value for the MSEL bits = 0.
>
> Is MSEL being changed before main? I'm using the Crossworks compiler.
>
> --- Rich
>
Reply by richdinoso●October 30, 20082008-10-30
When I enter main, bits 4:0 of PLL0CFG = 4 (those are the MSEL bits).
I was curious why this is the case, because page 30 of the user manual
says the reset value for the MSEL bits = 0.
Is MSEL being changed before main? I'm using the Crossworks compiler.