oops, sorry. Now A2 moves. I have to write to 0x83000004 to make it
move. Sorry. I hope this at least helps somebody else.

-- bugfixer

Oh, a typo:

"The symptom is that when I write to 0x83000001 A2 does not go to 1. "

is the correct information.

Hello to you all.

Has anybody used successfully the SED1335 device in bus mode with LPC
2294 (the ARM7 from Philips)?

I'm using a Phytec development board, which uses the A2 address bus as
the lowest bit for the addresses. The register BCFG3 seem to correctly
set:

BCFG3 -->  0x0000FBEF

bit memory access, RBLE = 0, IDCY=15,  WST1=31, WST2=31.

I have also set PINSEL2 to 0x0E6149E4, using the bus in A2-A23,
enabling CS3 (at address 0x83000000).

The symptom is that when I write to 0x83000000 A2 does not go to 1.

Any idea? 

thank you in advance -- bugfixer