Reply by Wouter van Ooijen●August 9, 20092009-08-09
> You can try lpc21isp. I'm pretty sure it will
work with a USB->Serial
> cable but I don't remember ever doing it.
Works like a charm over here, both with an off-the-shelve converter
(probably prolific chip set) and with an FT2232C (half openocd wiggler,
half serial interface for ISP). But IIRC the port must be set to COM4 or
lower.
--
Wouter van Ooijen
-- -------
Van Ooijen Technische Informatica: www.voti.nl
consultancy, development, PICmicro products
docent Hogeschool van Utrecht: www.voti.nl/hvu
--- In l..., "jdauchot" wrote: >
> There always been a problem using USB to UART conection with Flash magic. I
flag it to flash magic people and nothing came of it
>
> Regards
>
> Jean-Jacques
> --- In l..., "jacek.skorzynski" wrote:
> >
> > Hi
> > I am writing because, I need latest version Flash Magic eg. 4.35m. I have
problem with my LPC2148. I don't connect by USB my test board. I Always
give this same error "Failed To Autobaud". Computer detect device- Serial port
and USB serial Converter(chip USB<=>UART is FTDI FT232BL ) but I don't
have a communication with uC. Please Help me... I am devastated:(
>
You can try lpc21isp. I'm pretty sure it will work with a USB->Serial
cable but I don't remember ever doing it.
The latest version is available in the Files folder of the lpc21isp group here
on Yahoo. Version 1.60 is available in the Files folder of this group
(lpc2000).
Richard
Reply by jdauchot●August 9, 20092009-08-09
There always been a problem using USB to UART conection with Flash magic. I flag
it to flash magic people and nothing came of it
Regards
Jean-Jacques
--- In l..., "jacek.skorzynski" wrote: >
> Hi
> I am writing because, I need latest version Flash Magic eg. 4.35m. I have
problem with my LPC2148. I don't connect by USB my test board. I Always
give this same error "Failed To Autobaud". Computer detect device- Serial port
and USB serial Converter(chip USB<=>UART is FTDI FT232BL ) but I don't
have a communication with uC. Please Help me... I am devastated:(
>
Reply by "jacek.skorzynski"●August 9, 20092009-08-09
Hi
I am writing because, I need latest version Flash Magic eg. 4.35m. I have
problem with my LPC2148. I don't connect by USB my test board. I Always
give this same error "Failed To Autobaud". Computer detect device- Serial port
and USB serial Converter(chip USB<=>UART is FTDI FT232BL ) but I don't
have a communication with uC. Please Help me... I am devastated:(