Reply by el_s...@yahoo.com●March 26, 20062006-03-26
Its an 80C196KD. Intel ICE on 486. IC-96 C compiler.Not using JTAG.
no_spam_pats@etoolsmiths.com wrote:
> Could you tell us:
> What micro processor
> What ICE? JTAG ICE or Full ICE
> Thanks
> Pat
>
> Embedded Toolsmiths
> www.etoolsmiths.com
>
> "Rene Tschaggelar" <none@none.net> wrote in message
> news:441fcea9$0$720$5402220f@news.sunrise.ch...
> > el_squid_2000@yahoo.com wrote:
> >
> > > I have a situation where after performing a halt and re-going on the
> > > ICE I am using, one of the interrupts effectively becomes disabled,
> > > ie.. its like it has become masked, however I have checked the
> > > interrupt mask afterwards and its still intact.. And its only one
> > > interrupt which is being affected. Maybe a hardware issue.. Its an
> > > older system so who knows. Any help appreciated.
> >
> > A bit more information could tear us out of pure
> > guessing.
> >
> > Rene
> > --
> > Ing.Buero R.Tschaggelar - http://www.ibrtses.com
> > & commercial newsgroups - http://www.talkto.net
Reply by ●March 24, 20062006-03-24
Could you tell us:
What micro processor
What ICE? JTAG ICE or Full ICE
Thanks
Pat
Embedded Toolsmiths
www.etoolsmiths.com
"Rene Tschaggelar" <none@none.net> wrote in message
news:441fcea9$0$720$5402220f@news.sunrise.ch...
> el_squid_2000@yahoo.com wrote:
>
> > I have a situation where after performing a halt and re-going on the
> > ICE I am using, one of the interrupts effectively becomes disabled,
> > ie.. its like it has become masked, however I have checked the
> > interrupt mask afterwards and its still intact.. And its only one
> > interrupt which is being affected. Maybe a hardware issue.. Its an
> > older system so who knows. Any help appreciated.
>
> A bit more information could tear us out of pure
> guessing.
>
> Rene
> --
> Ing.Buero R.Tschaggelar - http://www.ibrtses.com
> & commercial newsgroups - http://www.talkto.net
Reply by Rene Tschaggelar●March 21, 20062006-03-21
el_squid_2000@yahoo.com wrote:
> I have a situation where after performing a halt and re-going on the
> ICE I am using, one of the interrupts effectively becomes disabled,
> ie.. its like it has become masked, however I have checked the
> interrupt mask afterwards and its still intact.. And its only one
> interrupt which is being affected. Maybe a hardware issue.. Its an
> older system so who knows. Any help appreciated.
Reply by el_s...@yahoo.com●March 21, 20062006-03-21
I have a situation where after performing a halt and re-going on the
ICE I am using, one of the interrupts effectively becomes disabled,
ie.. its like it has become masked, however I have checked the
interrupt mask afterwards and its still intact.. And its only one
interrupt which is being affected. Maybe a hardware issue.. Its an
older system so who knows. Any help appreciated.
Thanks in advance,
Slavko