Reply by Onestone April 18, 20132013-04-18
Thanks, I have an old data sheet and that isn't in it. I'd prefer
Mouser, they're usually cheaper than Digikey, and offer free shipping
over a certain point, even to Aus, but it doesn't matter too much, I'm
just looking ahead.

It always struck me as strange that Ti never included a small
cable/extra header in the dongle kit. I'm sure I'm not the only one who
uses the dongles as my main programming tool, and, because I couldn't
find that information when I first started using the dongle I have
standardised on an M30-110400, and just been too lazy to change before now.

Al

On 19/04/2013 1:14 AM, david_mcminn wrote:
> There's an FAQ in the eZ430 Users Guide (SLAU176D) that says:
>
> "6. What are the part numbers for the connectors between the MSP-EZ430U emulator and the MSP-EZ430D target board?
> Header: Mill-Max 850-10-004-20-001000 (Digi-Key part number ED8650-ND)
> Socket: Mill-Max 851-93-004-20-001000 (Digi-Key part number ED8850-ND)
> Mill-Max: http://www.mill-max.com"
>
> Is that what you need or are you looking for a distributor other than Digi Key?
> --- In m..., Onestone wrote:
>> Does anybody know where I can find the connectors used on the
>> EZ430-2013, the little 4 pin one to the micro board?
>>
>> thanks
>>
>> Al
>>

Beginning Microcontrollers with the MSP430

Reply by david_mcminn April 18, 20132013-04-18
There's an FAQ in the eZ430 Users Guide (SLAU176D) that says:

"6. What are the part numbers for the connectors between the MSP-EZ430U emulator and the MSP-EZ430D target board?
Header: Mill-Max 850-10-004-20-001000 (Digi-Key part number ED8650-ND)
Socket: Mill-Max 851-93-004-20-001000 (Digi-Key part number ED8850-ND)
Mill-Max: http://www.mill-max.com"

Is that what you need or are you looking for a distributor other than Digi Key?
--- In m..., Onestone wrote:
>
> Does anybody know where I can find the connectors used on the
> EZ430-2013, the little 4 pin one to the micro board?
>
> thanks
>
> Al
>

Reply by Onestone April 18, 20132013-04-18
Does anybody know where I can find the connectors used on the
EZ430-2013, the little 4 pin one to the micro board?

thanks

Al