Reply by ra ●January 7, 20042004-01-07
Hello VT

I don't know that particular EVB, but in general, POD mode means you
are using this MCU to program a second EVB.
And the BDM-out only connects to BDM-in on the other MCU board, not to
a serial port.
The EVB in POD mode does the translation between the PC's serial port
and the target EVB's BDM-in.

best regards
Robert

>
> Hi,
> I'm using MC68HC912B32 EVB, and trying to use POD mode with Serial
> Device Interface(SDI) from Motorola to free the SCI port for other
> purpose.
> I connect the 6pin header to the BDM out, set jumper J1 to A, J2 to B
> as said in User Manual, turn on power, do communication settings,
> however, my MCUez debugger doesn't seem to detect the board.
> Anyone experienced in this pls give me a hint how to go, thanks alot!
> VT




Reply by a2vutuan ●January 7, 20042004-01-07
Hi,
I'm using MC68HC912B32 EVB, and trying to use POD mode with Serial
Device Interface(SDI) from Motorola to free the SCI port for other
purpose.
I connect the 6pin header to the BDM out, set jumper J1 to A, J2 to B
as said in User Manual, turn on power, do communication settings,
however, my MCUez debugger doesn't seem to detect the board.
Anyone experienced in this pls give me a hint how to go, thanks alot!
VT