Thanks, Robert:
The problem occurs though I'm not touching PINSEL2 or
the Debug port.
The processor seems to go back to some kind of altered
state, since my simple program which blinks an LED on
P2.29 doesn't run, but the bootloader still runs if I
bring P0.14 low.
Normally the bootloader only runs on reset, and
bringin P0.14 low after that won't re-start the
bootloader.
--- Robert Wood <> wrote:
> I had very similar problems (I think) on the
2294.
> You have to be very careful
> how you set the PINSEL bits. I assume, when you say
> the processor doesn't
> run, the debug function doesn't work?
>
> I'm not sure of the exact differences between the
> 2294 and the 2214, but with
> the 94 I had to initialise PINSEL2 as below for it
> to not disable the debug
> interface.
>
> // Now PINSEL2 which configures debug lines and
> address and data lines
> temp = PINSEL2;
> temp |= 0x0F814920;
> temp &= ~0x08; // Take it out of trace mode...
> PINSEL2 = temp;
>
> Hope this is of some help.
>
> Cheers,
>
> Rob
--------------------------
> I'm running an LPC2214.
> I'm using P2.29 as an output to flash an LED, so I
> know that the processor is exacuting my program.
> If I include a line to set P1.16 as output, the
> processor does not run.
> If I change that line so that P1.16 remains an
> input,
> or delete that line, the program runs fine.
> On my board, P1.16 is not connected to anything.
> I have a 10k pullup resistor on P1.20 so as I
> understand it, the P1 pins should be GPIO, not Trace
> port.
> If I bring P0.14 low while the processor is frozen,
> the bootloader immediately runs without my having to
> reset the processor, and Philips' flash utility can
> program the chip.
> If I leave P0.14 high while the processor is frozen,
> the bootloader doesn't run and Philips' flash
> utility
> can't program the chip.
> I'm using the Keil demo version compiler.
> Can anyone see something I'm doing wrong?
> #define IODIR1 (*((volatile unsigned long *)
> 0xE0028018))
> #define IOSET2 (*((volatile unsigned long *)
> 0xE0028024))
> #define IODIR2 (*((volatile unsigned long *)
> 0xE0028028))
> #define IOCLR2 (*((volatile unsigned long *)
> 0xE002802C))
> int main (void)
> {
> unsigned long i;
>
> IODIR2 = 0x20000000; //P2.29=output
> IODIR1 = 0x00010000; //P1.16=output. This line
> causes the problem.
> while (1)
> {
> IOSET2 = 0x20000000; //P2.29 on
>
> i = 2000000; //delay
> while (--i);
>
> IOCLR2 = 0x20000000; //P2.29 off
>
> i = 2000000; //delay
> while (--i);
>
> }
> }
>
>
> Yahoo! Groups Links
|