Reply by Wolfgang Mahringer November 8, 20062006-11-08
Hi,

romi29@gmail.com wrote:
> I am very new to PIC C programming and i want to > configure the control register of the ADC and program in such a manner > that i can direct the ADC to happen according to my choice of > channels.Like say if i want channel 1 to be activated and perform adc > and then channel 2 ..then again channel 1..i shud be able to do so > according to my choice.
You did not say *waht* PIC you want to use. So I'll assume a PIC16 type here. It has 2 config registers: ADCON1: where you select how many and what inputs are analog inputs. Typically, you set up ADCON1 once at startup. ADCON0: where you select channel, speed and format of the conversion. Read up on your chip's datasheet. It is everything there, even sample code. HTH Wolfgang -- From-address is Spam trap Use: wolfgang (dot) mahringer (at) sbg (dot) at
Reply by November 8, 20062006-11-08
Hello everybody,

                   I am very new to PIC C programming and i want to
configure the control register of the ADC  and program in such a manner
that i can direct the ADC to happen according to my choice of
channels.Like say if i want channel 1 to be activated and perform adc
and then channel 2 ..then again channel 1..i shud be able to do so
according to my choice.
                      I am trasfering the digitized data thru RS232 n
saving it in hex format.
 CAN anybody plz help me with the configuration of the control register
(ADCON) which will help me to perform the adc over multiple channels
and to set the interrupts and the ADC ports accordingly???
                       Thanks a lot
        eagerly waiting for responses.
                    
regards 
chinmayee