The wiggler I am using a cloned one. RTCK(24) is pulled down using 4.7K
resistor, TRST(20) is pulled high by 4.7K. 16MHz and 32.768KHz crystals are
connected properly.
Sudip
Leon Heller <leon.heller@leon...> wrote:
----- Original Message -----
From: "sudipnag1" <sudipnag1@sudi...>
To: <lpc2000@lpc2...>
Sent: Friday, April 22, 2005 3:22 PM
Subject: [lpc2000] JTAG Programming for LPC2138
>
>
> I have tried to program a fresh/new LPC2138 using Wiggler and Cross
> Studio 1.4. After creating a new project and copying a sample program
> I have built the code. But unable to initialize JTAG port (The message
> is "Cannot identify target. Check JTAG connections and that the
> target is powered". The chip was powered and JTAG connection was
> correct. What may be the possible reason for this??
----- Original Message -----
From: "sudipnag1" <sudipnag1@sudi...>
To: <lpc2000@lpc2...>
Sent: Friday, April 22, 2005 3:22 PM
Subject: [lpc2000] JTAG Programming for LPC2138
>
>
> I have tried to program a fresh/new LPC2138 using Wiggler and Cross
> Studio 1.4. After creating a new project and copying a sample program
> I have built the code. But unable to initialize JTAG port (The message
> is "Cannot identify target. Check JTAG connections and that the
> target is powered". The chip was powered and JTAG connection was
> correct. What may be the possible reason for this??
I have tried to program a fresh/new LPC2138 using Wiggler and Cross
Studio 1.4. After creating a new project and copying a sample program
I have built the code. But unable to initialize JTAG port (The message
is "Cannot identify target. Check JTAG connections and that the
target is powered". The chip was powered and JTAG connection was
correct. What may be the possible reason for this??