Hi everyone,

I'm trying to interface an external ADC with the MSP430F1611's SPI.

I've written the code to initialize the SPI (seen below), but I now
want to test my Init_SPI by writing some data to it and probing it
using the scope to see that I've written data to it.

Eventually, I want to get data from an external ADC using SPI and
store it in memory.

Can anyone point me in the right direction?

Thank you so much! Much appreciated.

- Amy


====================INIT_SPI=========================

void Init_SPI(void)
{
  P3SEL |= 0x3F;		      // Select P3.0,1,2,3,4,5
  P3DIR |= 0x0B;                    // Select P3.1,3 as output
directions
  P3OUT &= ~0x01;
  ME1 |= USPIE0;                    // ENABLE USART0 SPI
  UCTL0 |= CHAR + SYNC + MM;        //  8-bit data, SPI mode
  UTCTL0 |=  CKPH + CKPL + SSEL1;  //  Inv.delay, ACLK
  UBR00 = 0x2A;                     // Baud Rate = 115200
  UBR10 = 0x0;
  UMCTL0 = 0x0;                     // Clear Modulation
  UCTL0 &= ~SWRST;                  // Initialize USART state machine

  //_BIS_SR(LPM3_bits + GIE);         // Enter LPM0 w/interrupt

} //end Init_SPI

===============================================