I have a very similar problem here too, after erasing the contents of the flash
on my hw platform I could not use JTAG to reflash it again with similar
problems:
sd config output:
** Emulator Test **
$$ EmuProductName=XDS510USB
$$ EmuPortAddr=0x510
$$ EmuPortMode=USB
$$ ProductIdQ0
$$ ProductVersion
** Emulator Scan Test
ERROR >> JTAG IR scan test failed
Any help is very much appriciated!
I bought the eZ DSP TM320F2812, ok cool! I set the port to 0x378 in SPP8
mode, to verify I got this
>$$ You are connected to:
> $$ EmuProductName=XDS510PP_PLUS
> $$ EmuPortAddr=0x378
> $$ EmuPortMode=SPP8
> $$ ProductId
> $$ ProductVersion
>
> but when I try to test the emulator I got this message:
>** Emulator Test **
> $$ EmuProductName=XDS510PP_PLUS
> $$ EmuPortAddr=0x378
> $$ EmuPortMode=SPP8
> $$ ProductId
> $$ ProductVersion
> ** Emulator Scan Test
>ERROR > > JTAG IR scan test failed
>
> > > Check power to your emulator/eZdsp
> > > Then check your port mode/address
>
>I notice that the DATA log it has the path for:
>binary file:c:\ti\specdig\examples\F28xx\dlog\sddlog and
>status file:c:\ti\specdig\examples\F28xx\dlog\dlstat.txt
>but, since Im using the CCs v3.1 I dont have this directory, and also I bought
the CCs IDE (C2000). It suppose that it is enough with this CD or the one that
is included in the starter kit, that is CCs 3.1 too.
>
>Somebody could help me to figure it out this issue!!!!!
> Regards